Re: complete answer from Roger

Hi Leif and all,

Thanks for your answers to my questions posed on October 31.  Your 
reward is a new set of questions about Linrad features ... 

1. The Network capability does not seem to exist in recent Linrad 
versions.  Is this correct, or am I missing something about starting it up?

2. References to a file dsp_uiparm still exist on the Linrad Home Page, 
but the functions of this file seem to have moved to par_userint.  Is 
this correct?

3. What has happened to the startup question about using memlock?  Is 
this no longer used, or no longer a user-level parameter?

4. Figure 1 on the page 
http://www.nitehawk.com/sm5bsz/linuxdsp/linroot.htm shows a noise
blanker operating between timf3 and fft3.  Am I right that this blanker 
is not yet implemented?

5. At the bottom of page
http://www.nitehawk.com/sm5bsz/linuxdsp/run/widegr.htm we read
"Secondary signals are selected or deselected with the left mouse 
button, which also can deselect the main signal."  The "help.lir" 
message [2] says "Right button selects secondary frequency for decode cw 
to ascii on screen only (not yet implemented)."

What is the true status of secondary signals?  I find that 
genparm[MIX1_NO_OF_CHANNELS] is set to 1 (I am not using AFC), and 
therefore secondary signals cannot be activated.  Perhaps this is 
intentional?

6. On page http://www.nitehawk.com/sm5bsz/linuxdsp/run/widegr.htm we
find that it should be possible to pause and resume the waterfall (which 
waterfall??) by using the Pause key.  I can't see that the Pause key has 
any effect at all.  Has it been de-activated?  I would like to be able 
to make both waterfalls pause (or at least go black) when one is 
transmitting, to avoid having them filled with eye-straining white.

	-- 73, Joe, K1JT

#############################################################
This message is sent to you because you are subscribed to
  the mailing list <linrad@...>.
To unsubscribe, E-mail to: <linrad-off@...>
To switch to the DIGEST mode, E-mail to <linrad-digest@...>
To switch to the INDEX mode, E-mail to <linrad-index@...>
Send administrative queries to  <linrad-request@...>