terratec cinergy 400 cardbus

it seems that i cannot get this card working,
scantv/motv cannot find channels.

i have

suse 9.2 with suse
kernel 2.6.8-24.10-default and i have compiled/installed
video4linux-20050403-221421.tar.gz in
/lib/modules/2.6.8-24.10-default/updates/.

gpio shows these values: 0, 40000 and ffffffff

it shows 0, if i rmmod and modprobe saa7134,
it shows one time ffffffff if i booted without the card connected and 
when i connect the card,
it shows 40000 if i disconnect and connect the card.

if gpio is ffffffff,
one error is shown in the log
PCI: Error while updating region 0000:06:00.0/0 (21000000 != ffffffff)

this is my modprob.d/tv ( suse has splitted modprobe.conf )

alias char-major-81 videodev
options i2c-algo-bit bit_test=1
# YaST2 configured TV card
# vTuk.OlmBxFYThB9:SAA713X Audio+video broadcast decoder
alias char-major-81-0 saa7134
alias char-major-81-1 off
alias char-major-81-2 off
alias char-major-81-3 off

options saa7134 card=47 tuner=12 i2c_debug=1 i2c_scan=1 irq_debug=1 
core_debug=1 video_debug=1 oss_debug=1 gpio_tracking=1
options tuner tuner_debug=1
options tda9887 qss=0 debug=3

this is a log with gpio ffffffff

Linux video capture interface: v1.00
module ir_common unsupported by SUSE/Novell, tainting kernel.
module v4l1_compat unsupported by SUSE/Novell, tainting kernel.
module v4l2_common unsupported by SUSE/Novell, tainting kernel.
module video_buf unsupported by SUSE/Novell, tainting kernel.
module saa7134 unsupported by SUSE/Novell, tainting kernel.
saa7130/34: v4l2 driver version 0.2.12 loaded
saa7130/34: snapshot date 2005-04-04
PCI: Error while updating region 0000:06:00.0/0 (21000000 != ffffffff)
saa7133[0]: found at 0000:06:00.0, rev: 255, irq: 11, latency: 255, 
mmio: 0x21000000
saa7133[0]: subsystem: 1539:ffff, board: Terratec Cinergy 400 mobile 
[card=47,insmod option]
saa7133[0]: board init: gpio is ffffffff
saa7133[0]/core: hwinit1
saa7133[0]: gpio: mode=0xfffffff in=0x0000000 out=0xfffffff [pre-init]
saa7133[0]: dsp access error
saa7133[0]/oss: mixer input = TV
saa7133[0]: dsp access error
saa7133[0]: i2c xfer: < a0 00 >
saa7133[0]: i2c xfer: < a1 =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff 
=ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff 
=ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff 
=ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff >
saa7133[0]: i2c eeprom 00: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 10: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 20: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c xfer: < 01 >
saa7133[0]: i2c scan: found device  <at>  0x0  [???]
...
saa7133[0]: i2c scan: found device  <at>  0x40  [mpeg encoder (saa6752hs)]
...
saa7133[0]: i2c scan: found device  <at>  0x86  [tda9887]
...
saa7133[0]: i2c scan: found device  <at>  0xa0  [eeprom]
....
saa7133[0]: i2c scan: found device  <at>  0xc0  [tuner (analog)]
...
saa7133[0]/core: hwinit2
saa7133[0]/video: set tv norm = PAL
saa7133[0]/video: video input = 0 [Television]
saa7133[0]/video: set tv norm = PAL
saa7133[0]: dsp access error
saa7133[0]: dsp access error
saa7133[0]: dsp access error
saa7133[0]: dsp access error
saa7133[0]: dsp access error
saa7133[0]: dsp access error
module tuner unsupported by SUSE/Novell, tainting kernel.
saa7133[0]: i2c xfer: < 96 >
tuner 0-004b: chip found  <at>  0x96 (saa7133[0])
tuner 0-004b: type set to 12 (Alps TSBE5)
saa7133[0]: i2c xfer: < c0 >
module tda9887 unsupported by SUSE/Novell, tainting kernel.
saa7133[0]: i2c xfer: < 84 >
tda9885/6/7: chip found  <at>  0x84
tda9885/6/7: Oops: no tvnorm entry found
tda9885/6/7: writing: b=0xc2 c=0x10 e=0x00
tda9885/6/7: write: byte B 0xc2
 B0   video mode      : sound trap
 B1   auto mute fm    : yes
 B2   carrier mode    : Intercarrier
 B3-4 tv sound/radio  : AM/TV
 B5   force mute audio: no
 B6   output port 1   : high (inactive)
 B7   output port 2   : high (inactive)
tda9885/6/7: write: byte C 0x10
 C0-4 top adjustment  : 0 dB
 C5-6 de-emphasis     : no
 C7   audio gain      : 0
tda9885/6/7: write: byte E 0x00
 E0-1 sound carrier   : 4.5 MHz
 E6   l pll ganting   : 13
 E2-4 video if        : 58.75 MHz
 E5   tuner gain      : normal
 E7   vif agc output  : pin3+pin22 port
-- 
saa7133[0]: i2c xfer: < 84 00 c2 10 00 >
saa7133[0]: i2c xfer: < 85 =ff >
tda9885/6/7: read: 0xff
 after power on : yes
 afc            : + 12.5 kHz
 fmif level     : high
 afc window     : in
 vfi level      : high
saa7133[0]: i2c xfer: < 86 >
tda9885/6/7: chip found  <at>  0x86
tda9885/6/7: Oops: no tvnorm entry found
tda9885/6/7: writing: b=0xc2 c=0x10 e=0x00
tda9885/6/7: write: byte B 0xc2
 B0   video mode      : sound trap
 B1   auto mute fm    : yes
 B2   carrier mode    : Intercarrier
 B3-4 tv sound/radio  : AM/TV
 B5   force mute audio: no
 B6   output port 1   : high (inactive)
 B7   output port 2   : high (inactive)
tda9885/6/7: write: byte C 0x10
 C0-4 top adjustment  : 0 dB
 C5-6 de-emphasis     : no
 C7   audio gain      : 0
tda9885/6/7: write: byte E 0x00
 E0-1 sound carrier   : 4.5 MHz
 E6   l pll ganting   : 13
 E2-4 video if        : 58.75 MHz
 E5   tuner gain      : normal
 E7   vif agc output  : pin3+pin22 port
-- 
saa7133[0]: i2c xfer: < 84 00 c2 10 00 >
saa7133[0]: i2c xfer: < 85 =ff >
tda9885/6/7: read: 0xff
 after power on : yes
 afc            : + 12.5 kHz
 fmif level     : high
 afc window     : in
 vfi level      : high
tda9885/6/7: Oops: no tvnorm entry found
tda9885/6/7: writing: b=0xc2 c=0x10 e=0x00
tda9885/6/7: write: byte B 0xc2
 B0   video mode      : sound trap
 B1   auto mute fm    : yes
 B2   carrier mode    : Intercarrier
 B3-4 tv sound/radio  : AM/TV
 B5   force mute audio: no
 B6   output port 1   : high (inactive)
 B7   output port 2   : high (inactive)
tda9885/6/7: write: byte C 0x10
 C0-4 top adjustment  : 0 dB
 C5-6 de-emphasis     : no
 C7   audio gain      : 0
tda9885/6/7: write: byte E 0x00
 E0-1 sound carrier   : 4.5 MHz
 E6   l pll ganting   : 13
 E2-4 video if        : 58.75 MHz
 E5   tuner gain      : normal
 E7   vif agc output  : pin3+pin22 port
-- 
saa7133[0]: i2c xfer: < 86 00 c2 10 00 >
saa7133[0]: i2c xfer: < 87 =ff >
tda9885/6/7: read: 0xff
 after power on : yes
 afc            : + 12.5 kHz
 fmif level     : high
 afc window     : in
 vfi level      : high
saa7133[0]: registered device video0 [v4l2]
saa7133[0]: registered device vbi0
saa7133[0]/video: DCSDT: pll: not locked, sync: no, norm: SECAM

regards
reinhard

--
video4linux-list mailing list
Unsubscribe mailto:video4linux-list-request <at> redhat.com?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/video4linux-list